Seite 1 von 1

New Ron Woods muffler, backfire now

BeitragVerfasst: 8. Juni 2010 05:21
von Donny
I found a new Ron Woods low pipe racing MZ glasspack muffler, and installed it, pic attached. Lots more power, no stumbling, idles well at ~1200 RPM, and lot more noise. :mrgreen: I have the Bing vergasser. Alle is ok except for backfire pop when downshift and coast off-throttle through the new muffler. I think the vergasser needs jet change, possibly too lean on the pilot? No pop with the A2 muuffler before, but much more power now. How do I fix the backfire/pop through the muffler? Anyone done this or similar?

Also, I've never checked the valve adjustment. Could this also be causing the backfire? I know it's hard to diagnose as the possible causes are numerous, but I very much appreciate the advice of the experts here. Danke, Donny

Bild

Re: New Ron Woods muffler, backfire now

BeitragVerfasst: 8. Juni 2010 05:40
von knut
look here with your questions (there are many specialist)

Re: New Ron Woods muffler, backfire now

BeitragVerfasst: 8. Juni 2010 05:51
von Donny
Knut, many good specialists here too. :mrgreen: I will try the link. The best information I ever recieve is here though.

Re: New Ron Woods muffler, backfire now

BeitragVerfasst: 8. Juni 2010 05:59
von knut
Donny hat geschrieben: many good specialists here too.
:wink: :ja:

Re: New Ron Woods muffler, backfire now

BeitragVerfasst: 15. Juni 2010 15:25
von Donny
Alles ist jetzt okay! A larger needle jet (2.68) and idle jet (48), then readjusting the Bing mixture screw richer cured it. :mrgreen: